racing bike EXPORTS FROM THAILAND to USA

BUYING A BIKE: Please ask your Road Transport Dept & Customs IN YOUR COUNTRY to classify the bike you wish to buy. We cannot do this from our end. They will tell you the regulations then send to us and we will make sure to comply. Please do not ask us what the regulations are in your country as we ONLY ship to you & it is up to you to pay your end. Every country has different requirement and regulations and we are not responsible once we ship your bike. It is up to you to clear customs in your country as we cannot do this. If in doubt then do not buy. Some places like Nepal you can only import new bikes.

It is recommended that you contact one of the resources below for the most up-to-date regulations applying to your vehicle. For a copy of the free "Introduction Handbook for Complying with Regulations of Imported Vehicles" and for information on safety standards, contact:

U.S. Department of Transportation National Highway Traffic Safety AdministrationOffice of Vehicle Safety Compliance, NSA-32 400 Seventh St. S.W. Washington, D.C. 20590, U.S.A.

National Highway Traffic Safety Administration Hotline: (800) 424-9393 Fax: (202) 366-1034

For the EPA's fact sheet on emission control standards or for other inquiries regarding the importation of a vehicle, contact:

U.S. Environmental Protection Agency Investigations / Imports Section Manufacturers Operations Division (EN-340F) Washington, D.C. 20460, U.S.A. EPA Hotline: (202) 233-9660 Fax: (202) 233-9596

U.S. Department of Agriculture required that all bikes are free from foreign soil. We clean before shipping. Any modifications that must be made to a vehicle imported into the United States is based on the price paid or the invoice price. Contact your local customs office for the current duty rate.

Environmental (Emission) Standards

Vehicles sold in the United States are required to meet tailpipe and evaporative emissions standards as set by the federal government’s Environmental Protection Agency. In addition, in the case of one state, California, there are additional, more stringent requirements set by the state legislature. Federal government standards take precedent over state standards. All states have the option of adopting, without modification, California’s standards. No standards discriminate against imported vehicles. Motorcycles with a displacement of more than 49 cubic centimeters originally manufactured after December 31, 1977are subject to Federal emission standards. You may obtain copies from your nearest Customs office or by writing to U.S. Customs, P.O. Box 7407, Washington, D.C. 20044; or from American embassies and consulates abroad.

In Thailand we can issue an EM5 which is the highest emmission control standard here. Although one needs a release letter from the EPA (Environmental Protection Agency) stating that the bike is emmissions legal, and a letter from the DOT (department of Transportation) stating that it passes safety standards we do comply with this as our bikes are all put thru an emmissions test before shipment. There is no sticker on the bikes stating in English that it meets EPA standards but we have the correct information to have the bike released. in fact we have found by experience the customs in USA require mainly if the bike is legal so all information we give is valid as all bikes do have registrtaion & insurance compliance.

EPA also has a detailed automotive fact manual about emission requirements for motorcycle imports. Its called the Automotive Imports Facts Manual,or call EPA’s Imports Hotline at (202) 564-9240. fax: (202) 564-2057; write to U.S. Environmental ProtectionAgency,Ariel Rios Building, Manufactures Operations Division (6405-J), Investigation / Import Section, 1200Pennsylvania Avenue, N.W., Washington, D.C. 20460; or visit the Web site at http://www.epa.gov/otaq/imports.

DOT’s vehicle hotline at1-800-424-9393; communicate by fax at (202) 366-1024; or write to the National Highway Traffic Safety Administration (NSA-32), 400 7^thStreet, S. W. Washington, D.C. 20590.

PRIOR ARRANGEMENTS

The owner must make arrangements for shipping a vehicle. Have your shipper or carrier notify you of the vehicle’s arrival date so that you can make arrangements to process it through Customs. Shipments are cleared at the first port of entry unless you arrange for a freight forwarder abroad to have the vehicle sent in bond to a Customs port more convenient to you. Law prohibits Customs officers from acting as agents or making entries for an importer. However, you may employ a commercial customs broker to handle your entry and look for Freight Clearance agents in your yellow pages.

DOCUMENTATION

For Customs clearance you will need the shipper’s or carrier’s original bill of lading, the bill of sale, foreign registration, and any other documents covering the vehicle. You will also be required to complete EPA form 3520-1 and DOT form HS-7, declaring the emissions and safety provisions under which the vehicle is being imported. Vehicles that meet all U.S. emission requirements will bear manufacturer’s label on the engine compartment in English, attesting to that fact. For vehicles that lack such a label, the Customs inspector at the port of entry may require proof of eligibility to import under the EPA exemptions or exclusions specified on form 3520-1.

Vehicles that do not meet all U.S. emission requirements, unless eligible for exemption or exclusion must be imported through an independent commercial importer (ICI). EPA will not allow the vehicles’ release to the vehicle owner until ICI work is complete. The ICI will perform any EPA-required modifications and be responsible for assuring that all EPA requirements are met.

You should also inquire about any driver’s license and tag requirements.

http://www.epa.gov/otaq/imports/ FOR MORE INFO.

INFORMATION FOR RACING VEHICLE EXCLUSIONS

The vehicle has in general been extensively modified for racing, and is incapable of safe and practical street or highway use because it lacks features associated with safe and practical street or highway use, such features including, but not being limited to, a reverse gear (except in the case of motorcycles), a differential, or safety features required by state and/or Federal law. Anyone may import a racing vehicle without a Customs bond required by EPA; however, written EPA approval must be obtained before clearance at Customs.

Requirements

You must first receive EPA's approval. Not all vehicles used in races are excluded from emissions compliance. Determinations are based on the capability of the vehicle, not its intended use. Importer must submit the following information when applying:

Importer's name, address, and daytime telephone number.

vehicle information (make, model, model year and VIN);

a list of racing features (features that make the vehicle a racing vehicle);

a list of street features lacking (features that have been removed or have never been installed that would permit safe driving on streets or highways);

at least 4 photographs showing the front, rear, and each side view; and if a vehicle with an interior, photographs of the interior;

the current value of the vehicle/s in U.S. dollars;

copy of letter from the U.S. Department of Transportation (DOT) stating that they have no objection to this vehicle/s being imported for racing;

the name of the sanctioning body and competition class;

a schedule of racing events, including dates and locations where the vehicle will participate;

a copy of the competition racing license; and

other proof that the vehicle cannot be used on streets and highways, such as a letter from a state's Department of Motor Vehicles that explains the vehicle cannot be licensed for use on public roads, and explains why it cannot be licensed.

Importer must file with Customs, upon entry, an EPA Form 3520-1 declaring code "L" and attach EPA letter of approval; and

Importer should keep a copy of the EPA approval letter for future proof of EPA exclusion.

Restrictions

Vehicle may not be registered or licensed for use on or operated on the public roads or highways; and

If an imported racing vehicle is subsequently converted to a motor vehicle and registered or licensed for street use, the converter may be considered a manufacturer of a new motor vehicle and subject to a penalty of $25,000 per day for failing to meet EPA emission requirements.

Please Note: THE IMPORTER MUST ALLOW AT LEAST 10 WORKING DAYS FROM THE DATE ALL REQUIRED INFORMATION IS RECEIVED BY EPA TO PROCESS ALL RACING VEHICLE EXCLUSION APPLICATIONS. IF ALL THE REQUIRED INFORMATION IS NOT RECEIVED, THE CAN AND WILL DELAY THE PROCESS. If you have any additional questions that are not answered by this information sheet, you may contact:

John LaCroix

at Phone: (734) 214-4463 Fax: (734) 214-4053 Email: LaCroix.John@EPA.GOV

For delivery by courier service (e.g. Federal Express, UPS, USPS, etc.), ONLY use the following address:

U.S. Environmental Protection Agency Certification and Compliance Division

Attn: John Lacroix

RACING MACHINE: [ See pics ]

HONDA VFR 400CC RACER: Painted and setup to race. This bike has original reg papers and we can make ready for you. Has racing exhaust under the seat and totally professionally made for any client. New paint and fully rebuilt. We can offer the buyer racing slicks to suit price extra but available now. No headlights; just a racer. Slicks Battlax brand new; braided lines and 17"wheels costs around 150,000 baht

FOR IMMEDIATE DELIVERY ANYWHERE IN THE WORLD. If you want to buy any bike then ask us. We crate and send. All Hondas before dispatched go through a complete Honda dealership service check by us. All parts needed are instantly replaced. Please note 1st July 2004 shipping schedules have increased

THE SPECIAL SHAPE VFR RACING VERSION ROAD BIKES WE ARE NOW PREPARING. SEE MORE [ Pictures of racing fairings ] WE CAN CONVERT YOUR BIKE WITH THESE ADDITIONS. VFR & CBR 400 ONLY AT THIS STAGE. If you decide to buy your own bike in Thailand and just want us to ship for you then yes we can help you.

Go to: [ Export my bike ]

Model: VFR400 1990-1998 Capacity: 399cc Bore/Stroke: 55X42mm Weight: 185kg Tyre size: Rear: 150/60/18, Front: 120/60/17 Fuel cap.: 15+3Litres Front tyre = Torque 120/70Rear tyre = 150/60 (18" rim) Wheelbase = 1345mm Dry weight = 170kg Power = 56bhp @ 12,750rpm 26 lb-ft @ 9,700rpm

Model: NSR250R (MC21) Capacity: 249cc Bore/Stroke: 54X54.5mm Weight: 157kg Tyre size: Rear: 150/60/17, Front: 110/70/17 Fuel cap.: 16+1.2Litres

E.Mail us:

2006: All bikes are sent LCL in a container but look at min scooter 20,000 baht to max 27,000-32,000 baht for 2- 3cbm ( fumigation costs etc ) prices & Marine Insurance to add 2.5% on cost of the bikes. We quote full costings. If second hand the plates and papers must be declared to the Transport Dept in Thailand. All payments TT transfer when ordering before shipment. Please send port of entry when writing to us & full address details, tel & fax ( THIS IS THE NEAREST SHIPPING PORT NEAREST YOU). We are a registered Thai Company Export License Holder --- so you are covered using our Company.

BUYING A BIKE: Please ask your Road Transport Dept & Customs to classify the bike you wish to buy. We cannot do this from our end & do not pay your customs or road transport costs your end. They will tell you the requirements then you send to us and we will then comply.

COPYRIGHT: No parts or parts of this website may be copied, printed or circulated for publication in any form or part of without the express written permission of Asia Trading Post Co Ltd. Please also note all Thailand affected pages which include eg. law, immigration, visas can not be used unless written permission is obtained from both 29 Tanin Co Ltd--Law Office & also Asia Trading Post Co Ltd by way of contract. All infringements will be an infringement of privacy and our company will act accordingly. See FAQs